1. A saw mounted on the traction head near the extruder can be used to cut the parking or welding marks of the profiles to reduce the waste of profiles.

2. The double-head traction system does not need to rely on the non-extrusion cycle to rearrange the expected next extrusion cycle.

3. Using PLC control technology, the tractor provides 9 different operating procedures to adapt to different extrusion modes. Easy to operate.

4. Double-head traction allows the traction head to operate at a low speed.

(1) due to the introduction of 20-meter length limit, the larger extrusion speed of the extrusion profile is less than 35m/min.

(2) large return speed of 220m/min.

(3) matching non-extrusion time (invalid time) : 14 seconds. During the continuous production time of the extruder, the tractor affects the production efficiency of the extruder, that is, it is not allowed to wait for the return of the tractor.

(4) in traction, the control system can provide 1 KG of incremental change, traction adjustment range of 0 ~ 250KG.

5, traction machine in the process of traction shall not change the size of the extrusion profile, that is, no traction extrusion profile, traction extrusion profile size should be the same.

6, traction flying saw saw positioning accuracy: 200mm.

5. As a system, the double-end tractor provides higher output while reducing waste.

6. The extrusion speed can be increased by 10-30% (under the condition of mold strength).

7. The production efficiency can be improved by 10-20%.

8. The yield can be increased by 1 ~ 2%.